trying to import ova template into proxmox

[wa4zlw]

i've tried to upload the ova template and get the following error in a modal dialog box

Error 400: Parameter Verification failed

filename missing '.tar.gz' extension

[OK]

Where do we go from here?

Thanks

[wa4zlw]

while am not an expert on proxmox....i m loading the .ova and getting this error.

SO I am stumped.

thanks anyone else out there getting this working with prox?

[wa4zlw]

ok I've got a container running under proxmox with the centos download from this site. I have access to and from the internet through my router yet the "test" fails. see traceroute:

[root@Centos-OpenVPN ~]# traceroute 4.2.2.1
traceroute to 4.2.2.1 (4.2.2.1), 30 hops max, 60 byte packets
1 10.161.51.12 (10.161.51.12) 0.078 ms 0.014 ms 0.014 ms
2 24.115.160.1.res-cmts.flt.ptd.net (24.115.160.1) 19.259 ms 19.236 ms 21.001 ms
3 gateway-t3-2-flt1blocal1.flt.ptd.net (24.229.54.225) 9.859 ms 9.865 ms 9.851 ms
4 te-8-2.car3.washington1.level3.net (4.79.168.85) 118.063 ms 118.055 ms 118.062 ms
5 vlan60.csw1.washington1.level3.net (4.69.149.62) 20.977 ms 20.992 ms 21.015 ms
6 ae-62-62.ebr2.washington1.level3.net (4.69.134.145) 20.875 ms ae-61-61.ebr1.washington1.level3.net (4.69.134.129) 20.605 ms ae-62-62.ebr2.washington1.level3.net (4.69.134.145) 22.269 ms
7 ae-8-8.ebr1.washington12.level3.net (4.69.143.218) 20.512 ms 4.69.202.54 (4.69.202.54) 20.628 ms ae-8-8.ebr1.washington12.level3.net (4.69.143.218) 20.409 ms
8 ae-103-3503.edge1.washington12.level3.net (4.69.158.25) 20.596 ms ae-203-3603.edge1.washington12.level3.net (4.69.158.41) 20.582 ms ae-103-3503.edge1.washington12.level3.net (4.69.158.25) 20.363 ms
9 a.resolvers.level3.net (4.2.2.1) 20.422 ms 20.317 ms 20.373 ms
[root@Centos-OpenVPN ~]#


here are results from connectivity test when I was connected in at lunchtime from work:

Connectivity Test
This test checks whether VPN clients on the Internet will be able to reach your VPN Server.
Current Server Network Settings
The VPN Server is currently configured with these network settings:
Host Name IP Address Port Number Protocol
10.161.51.21 all 443 TCP
10.161.51.21 all 1194 UDP
The Connectivity Test attempts to determine the public IP address and FQDN (Fully-Qualified Domain Name) corresponding to the IP address: all, and also whether or not clients on the Internet will be able to connect to the VPN Server

Test Results for TCP
Result: General Connectivity Test Error
Explanation: UNCLASSIFIED_ERROR
IP Address Tested: (not found)
Reverse DNS result: (unknown)


Test Results for UDP
Result: General Connectivity Test Error
Explanation: UNCLASSIFIED_ERROR
IP Address Tested: (not found)
Reverse DNS result: (unknown)

Warning: Your configured Hostname or IP Address is '10.161.51.21' which is not a public IP address that VPN clients on the Internet can reach.
Perform Test Again
The connectivity test may take several seconds to complete, and will take additional time if both TCP and UDP protocols are being tested.

if I try and just start the server I get:

Error:

iptables service not started because of error (SVC_RUN_EXCEPT)
iptables service not started because of error (SVC_RUN_EXCEPT)

Status Overview
Server Status
The server is currently OFF
Active Configuration
Access Server version: 2.0.1
Server Name: 10.161.51.21
Authenticate users with: local
Accepting VPN client connections on IP address: all interfaces
Port for VPN client connections: tcp/443, udp/1194
OSI Layer: 3 (routing/NAT)
Clients access private subnets using: Routing
Node: Centos-OpenVPN.wa4zlw.homedns.org

any ideas where to look?

thanks leon