OpenVPN Support Forum

Posted: **Fri Jan 27, 2012 10:30 am**

Given the following setup:

I would like to get the initial IP of the tunnel assigned to br0 rather than tap0. I already have the tunnel/bridge configured in a persistent manner and receive an IP address. How can i have that assigned to br0 instead of tap0?

Posted: **Fri Jan 27, 2012 1:27 pm**

With the manual i was actually able to solve my problems, and can even use the serverside normal DHCP daemon. I guess i was still confused by some of the terminology this morning.

Posted: **Wed Mar 07, 2012 6:52 am**

Please post your Server config file and client config file.

Might be there is some issue in your config files.

OpenVPN Support Forum

Bridging on the client side, but ip goes to tap0, not br0

Bridging on the client side, but ip goes to tap0, not br0

Re: Bridging on the client side, but ip goes to tap0, not br

Re: Bridging on the client side, but ip goes to tap0, not br