Including multiple machines on the client side bridge mode??

tushar.sharma · Post by **tushar.sharma** » Tue Jan 24, 2012 1:43 pm

Can any one explain in detail about including multiple machines on client side using bridge.

Do we require to bridge lan nic and tap before starting connection or after that. ??

Thanking YOu
Tushar

tushar.sharma · Post by **tushar.sharma** » Tue Jan 24, 2012 1:56 pm

i will try both way and will let know which one works !!

Thanking You,
Tushar

Post by **Mimiko** » Wed Jan 25, 2012 7:54 pm

In bridge mode, first you setup the bridge (real interface and tap interface), then you start any VPN.

tushar.sharma · Post by **tushar.sharma** » Fri Jan 27, 2012 10:19 am

True but in that case machines behind client must use ip belonging to subnet of server
and in that case it will not be able to connect to other vpn server.

Thanking You
Tushar

Post by **Mimiko** » Fri Jan 27, 2012 10:42 am

tushar.sharma wrote:True but in that case machines behind client must use ip belonging to subnet of server
and in that case it will not be able to connect to other vpn server.

Yes, this is the concept of the bridge: make remote lan's common as if they where on the same switch.

tushar.sharma · Post by **tushar.sharma** » Fri Jan 27, 2012 2:15 pm

Okay, Got it.

Tushar

OpenVPN Support Forum

Including multiple machines on the client side bridge mode??

Including multiple machines on the client side bridge mode??

Re: Including multiple machines on the client side bridge mo

Re: Including multiple machines on the client side bridge mo

Re: Including multiple machines on the client side bridge mo

Re: Including multiple machines on the client side bridge mo

Re: Including multiple machines on the client side bridge mo