My objective is to have 2 interfaces on the OpenVPN server
eth1 - Public IP
eth2 - Private IP
Objective of VPN:
Remote Client -> Internet - -> Public VPN Interface -> Private VPN Interface - Private Network
When I use the Turnkey OpenVPN wizard to configure the server, it asks for the IP that is reachable by the clients and I give it the Public IP then it asks for the IP range to use to create the vpn tunnel. Once I give it that information, the OpenVPN web gui is accessible on the public IP. How do I build the server so that the openvpn gui opens on the private side but the clients connect to the public side?
Turnkey OpenVPN Server configuration
Moderators: TinCanTech, TinCanTech, TinCanTech, TinCanTech, TinCanTech, TinCanTech
-
- OpenVpn Newbie
- Posts: 2
- Joined: Thu Aug 18, 2022 5:09 pm
-
- OpenVPN Protagonist
- Posts: 11137
- Joined: Fri Jun 03, 2016 1:17 pm
-
- OpenVpn Newbie
- Posts: 2
- Joined: Thu Aug 18, 2022 5:09 pm
Re: Turnkey OpenVPN Server configuration
I have looked at the HOWTO but I do not see where it talks about having a Public Interface and a Private. It just talks about port forwarding a private IP
-
- OpenVPN Protagonist
- Posts: 11137
- Joined: Fri Jun 03, 2016 1:17 pm
Re: Turnkey OpenVPN Server configuration
You can configure your network as you see fit, using the tools you choose.
If you need help with Openvpn then ask ..
If you need help with Openvpn then ask ..