OpenVPN Support Forum

Good day. I have set up OpenVpn on a Pfsense firewall. After downloading the configuration exe, all seems fine and i can connect from my Win10 desktop to the openvpn. My setup is as follow :

Tunnel Network 10.200.0.0/22
Internal Network 172.16.1.0/24
Pfsense LAN IP 172.16.1.28/24
Host on Lan 172.16.1.29/24

Route Print from PC :
IPv4 Route Table
===========================================================================
Active Routes:
Network Destination Netmask Gateway Interface Metric
0.0.0.0 0.0.0.0 192.168.8.1 192.168.8.105 25
10.200.0.0 255.255.252.0 On-link 10.200.0.2 281
10.200.0.2 255.255.255.255 On-link 10.200.0.2 281
10.200.3.255 255.255.255.255 On-link 10.200.0.2 281
127.0.0.0 255.0.0.0 On-link 127.0.0.1 331
127.0.0.1 255.255.255.255 On-link 127.0.0.1 331
127.255.255.255 255.255.255.255 On-link 127.0.0.1 331
172.16.1.0 255.255.255.0 10.200.0.1 10.200.0.2 281
192.168.8.0 255.255.255.0 On-link 192.168.8.105 281
192.168.8.105 255.255.255.255 On-link 192.168.8.105 281
192.168.8.255 255.255.255.255 On-link 192.168.8.105 281
224.0.0.0 240.0.0.0 On-link 127.0.0.1 331
224.0.0.0 240.0.0.0 On-link 192.168.8.105 281
224.0.0.0 240.0.0.0 On-link 10.200.0.2 281
255.255.255.255 255.255.255.255 On-link 127.0.0.1 331
255.255.255.255 255.255.255.255 On-link 192.168.8.105 281
255.255.255.255 255.255.255.255 On-link 10.200.0.2 281

Once connected, i cannot ping the host ip 172.16.1.29/24. I CAN however, ping the PFsense LAN ip of 172.16.1.28/24

I am a total beginner on both PFsense and Openvpn. But followed multiple tutorials and the result stays the same. Can anyone please help me?

Solved by changing Nat to Hybrid on PfSense and re-doing the routes to my internal network