"Launch on User Logon" Issue
Posted: Tue Aug 24, 2021 2:33 pm
Hi there, hoping I can get some help or guidance on what I may be doing wrong.
I have an OpenVPN 2.5.3 install we are pushing out to end-users which uses the "ADDLOCAL" switches and it works almost perfectly:
msiexec /i C:\temp\OpenVPN-2.5.3-I601-amd64.msi ADDLOCAL=OpenVPN.GUI,OpenVPN.Service,OpenSSL,OpenVPN,OpenVPN.GUI.OnLogon,Drivers.TAPWindows6,Drivers,Drivers.Wintun /norestart
Everything appears to work as it should, except the "OpenVPN.GUI.OnLogon" option. When going into the GUI settings after install, this box remains unchecked and must be manually set. If there was an older version of OpenVPN installed that had this option checked in the settings already, it stays. However if its a new install, or installing over top of an existing install that did not have that option checked, it does not get selected even though that "OpenVPN.GUI.OnLogon" is present.
I was hoping there may be some entry in the registry I could change/add but nothing sticks out to me.
Any insights? Thanks!
I have an OpenVPN 2.5.3 install we are pushing out to end-users which uses the "ADDLOCAL" switches and it works almost perfectly:
msiexec /i C:\temp\OpenVPN-2.5.3-I601-amd64.msi ADDLOCAL=OpenVPN.GUI,OpenVPN.Service,OpenSSL,OpenVPN,OpenVPN.GUI.OnLogon,Drivers.TAPWindows6,Drivers,Drivers.Wintun /norestart
Everything appears to work as it should, except the "OpenVPN.GUI.OnLogon" option. When going into the GUI settings after install, this box remains unchecked and must be manually set. If there was an older version of OpenVPN installed that had this option checked in the settings already, it stays. However if its a new install, or installing over top of an existing install that did not have that option checked, it does not get selected even though that "OpenVPN.GUI.OnLogon" is present.
I was hoping there may be some entry in the registry I could change/add but nothing sticks out to me.
Any insights? Thanks!