Seamless tunnel does not engage after reconnect
Posted: Sun Aug 01, 2021 4:53 am
Hi there,
I wrote a little shell bat file and check my ip once every second. I wanted to check how the Openvpn Connect behaves when there is wifi disconnect. So while i was printing my ip (which was my vpn ip) on cmd terminal, I disconnected the internet (disconnected from wifi). At this time, the on/off switch in the Openvpn Connect app turned orange indicating that it is trying to reconnect. Through out the entire time the seamless tunnel is checked.
Now, while still printing my ip on the code terminal, I connected the wifi back. And, here is the problem, for maybe 1 or 2 seconds, I noticed that the shell printed my non-vpn ip.
Is this a known issue? Am I missing something?
Thank you!
I wrote a little shell bat file and check my ip once every second. I wanted to check how the Openvpn Connect behaves when there is wifi disconnect. So while i was printing my ip (which was my vpn ip) on cmd terminal, I disconnected the internet (disconnected from wifi). At this time, the on/off switch in the Openvpn Connect app turned orange indicating that it is trying to reconnect. Through out the entire time the seamless tunnel is checked.
Now, while still printing my ip on the code terminal, I connected the wifi back. And, here is the problem, for maybe 1 or 2 seconds, I noticed that the shell printed my non-vpn ip.
Is this a known issue? Am I missing something?
Thank you!