OpenVPN Support Forum

So i'm new to openVPN, after setting it up, and connecting between client - server , i need both to allow LAN connection

So my setup is as follow (as for now) Client is set on the 192.168.1.X ip range Server is set on the same range (OpenVPN is installed on 192.168.1.2) Gateway on server "network" is 192.168.1.254

i need the client to connect to server and , for example, access a smb share on it

This is both the Server and Client ovpn file







I know it sucks just "asking" for it, but tried changing to dev tap, routing, etc and i just can't seem to figure it out.

Any help would be helpful

HelderIngor wrote: ↑

Tue Oct 08, 2019 11:16 am

Client is set on the 192.168.1.X ip range Server is set on the same range

And if you read your logs you will find this:

NOTE: your local LAN uses the extremely common subnet address 192.168.0.x or 192.168.1.x. Be aware that this might create routing conflicts if you connect to the VPN server from public locations such as internet cafes that use the same subnet.

So change them for a start. At least change your server LAN.

I'm still testing it locally, so it's kind of hard connecting to another network.

But i did an Hotspot, with no connection to the main network from my cellphone, on 192.168.43.x and i still can connect, but i can't see the "main lan"


UPDATE:

So after trial and error, i got the 2 machines to recognize themselves, by their "tunnel ip"

The server is on 10.10.10.1 and client is 10.10.10.5 and they can both ping each other

Now, how do i make the client see for example, the whole network (my windows server is on 192.168.1.2)

if you want to see the "main lan" you must run your dns server and WINS server so windows client can see the main lan , you install on windows server it is simple to install dns and wins server so everything will work for you ,