OpenVPN Support Forum

Hi, I have setup openvpn on my raspberry Pi at home so I can access my home network from anywhere this is all working great. However, I want to enable my firewall on the Pi but when I do I cannot access the Internet on connected devices or access other devices on the home network.

Currently I am having to connect to the VPN, then SSH to the Pi (via its local address), disable the firewall, do whatever I wanted to do then enable the firewall again when I am finished.

Anyone know what I need to allow through? I have tried to alow all local (192.168.1.0/24) and all VPN range local traffic (10.8.0.0/24) but it's still not working.

Many thanks,
Jack

Allow all and install fail2ban.

Hi Traffic,

Thanks for your reply and I will checkout fail2ban as it could be a nice addition.

But my issue must be a Pi firewall rule issues as when I disable the Pi firewall it all works fine.

I would like to use my current firewall (UFW) but perhaps fail2ban in addition. I understand with fail2ban people COULD (& I know it's unlikely) access services (if they guessed the password early enough).

With the firewall I can block certain internal ports from everyone except the computer that I need it to access.


Sent from my iPhone using Tapatalk

The solution that worked for me is:
Then find: Change to: Hope this helps someone!