I have an OpenVPN server setup in OPNSense that include TOTP two-factor authentication. Where do I put the two-factor code in the OpenVPN Connect client?
I don't see anywhere to enter it and when I try to connect it doesn't bring up a prompt or anything - it just says "Authentication Failed".
Where to enter two factor code in client
-
VECCTOR
- OpenVpn Newbie
- Posts: 1
- Joined: Fri Dec 02, 2022 5:34 am
-
openvpn_inc
- OpenVPN Inc.
- Posts: 1159
- Joined: Tue Feb 16, 2021 10:41 am
Re: Where to enter two factor code in client
Hello VECCTOR,
Most likely the authentication fails before you even get to the MFA. Once username/password authentication succeeds, then MFA should be requested. If username/password already fails, you may not even get an MFA request.
Kind regards,
Johan
Most likely the authentication fails before you even get to the MFA. Once username/password authentication succeeds, then MFA should be requested. If username/password already fails, you may not even get an MFA request.
Kind regards,
Johan
OpenVPN Inc.Answers provided by OpenVPN Inc. staff members here are provided on a voluntary best-effort basis, and no rights can be claimed on the basis of answers posted in this public forum. If you wish to get official support from OpenVPN Inc. please use the official support ticket system: https://openvpn.net/support
-
MateoSJ
- OpenVpn Newbie
- Posts: 2
- Joined: Wed Feb 15, 2023 10:51 pm
Re: Where to enter two factor code in client
I have the same problem. If my method for MFA is a code to enter, where do I put it? If my method is approving by authenticator or with phone call and pressing # to approve, it works fine. I need options for entering code? I am using Microsoft NPS setup with OpenVPN (PFSense)