I connect to a OpenVPN server that connects to an off-site network.
I get the OpenVPN client running and I can ping the VPN server. The server doesn't push any routes so I need to route on the client.
Adding the off-site networks to route to the VPNserver so that I can access the off site network.
So the problem I have is that my requests don't jump from 192.168.0.1 network to the off site 172...* one... Can I do anything about that on my client? I don't have any ownership of the server and routs are not pushed from server now , in the future i don't know
tun0 Link encap:UNSPEC HWaddr 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
inet addr:10.242.2.6 P-t-P:10.242.2.5 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:100 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:0 (0.0 B) TX bytes:12129 (12.1 KB)
wlan1 Link encap:Ethernet HWaddr 5c:93:a2:a0:6e:1b
inet addr:10.101.7.41 Bcast:10.101.31.255 Mask:255.255.224.0
inet6 addr: fe80::5e93:a2ff:fea0:6e1b/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:355109 errors:0 dropped:0 overruns:0 frame:0
TX packets:206832 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:454685028 (454.6 MB) TX bytes:23942624 (23.9 MB)
Kernel IP routing table
Destination Gateway Genmask Flags MSS Window irtt Iface
0.0.0.0 10.101.0.1 0.0.0.0 UG 0 0 0 wlan1
10.101.0.0 0.0.0.0 255.255.224.0 U 0 0 0 wlan1
10.242.2.1 10.242.2.5 255.255.255.255 UGH 0 0 0 tun0
10.242.2.5 0.0.0.0 255.255.255.255 UH 0 0 0 tun0
192.168.0.0 10.242.2.5 255.255.255.0 UG 0 0 0 tun0
192.168.82.0 10.242.2.5 255.255.255.0 UG 0 0 0 tun0