Reinstalling OpenVPN to show install driver screen again

This forum is for all inquiries relating to the installation of OpenVPN from source and with binaries.
Forum rules
Please visit (and READ) the OpenVPN HowTo http://openvpn.net/howto prior to asking any questions in here!
Post Reply
cyberkryption
OpenVpn Newbie
Posts: 1
Joined: Wed Dec 06, 2017 10:14 am

Reinstalling OpenVPN to show install driver screen again

Post by cyberkryption » Wed Dec 06, 2017 10:27 am

Hello Everyone,

Here is my issue, I have an openvpn install that will not install on a Dell Laptop , we will call this laptop 1. I have an identical Dell laptop, called laptop 2 which installed ok.

I have followed information here to debug - see https://community.openvpn.net/openvpn/w ... TAPDrivers

I have followed section 7 and removed drivers via pnputil and looked at the setup.api.dev.log.

In setup.api.log it clearly states that the driver is not trusted and fails because win10 does not allow untrusted drivers.

Failed Install
https://pastebin.com/tpLaQ6f0

Good install
https://pastebin.com/UMHXZ0ga

Both dell laptps are win10 with secure boot and are bitlocker encrypted. I therefore can do something like set testsigning on via bcdedit as it will break the boot sequence.

I think the problem is that when i installed it on laptop1 I did not specify 'always trust this driver' at the TAP driver install prompt.

How do I get the installer to rerun and re show me the screen to set the 'always trust' option

Any help appreciated

Paul

User avatar
TinCanTech
OpenVPN Protagonist
Posts: 4917
Joined: Fri Jun 03, 2016 1:17 pm

Re: Reinstalling OpenVPN to show install driver screen again

Post by TinCanTech » Wed Dec 06, 2017 2:25 pm

Your log:

Code: Select all

137: !!!  ndv: Error 0xe0000248: The installation of this device is forbidden by system policy. Contact your system administrator.
See your system policies.

Post Reply