Cannot attach to Access Server
Posted: Fri May 29, 2020 2:00 am
I thought I'd give OpenVPN Access Server a try and see if I could use it to replace our Microsoft L2TP/IPsec server.
1.) I installed Ubuntu 18.04.4 and the installed OpenVPN Access Server using the scripts.
2.) I opened ports 443 and 1194 on our router and pointed them to the IP address of the OpenVPN Access Sever.
I can successfully log into the Admin UI and the User UI from outside our network using the openvpn admin username and password..
Next, I log into the User UI and click the "OpenVPN Connect Recommended for your device" to download and install the OpenVPN Connect Setup Wizard. So far so good.
When I launch OpenVPN connect, I click on the "OpenVPN Profile" that was created by the installation wizard and enter my username and password. (NOTE: I'm using the openvpn admin username and password since I know that account works.)
After about a minute, it times out with the following error message. "There was an error attempting to connect to the selected server" With the option to, "Cancel" or "Retry"
When I click on the log file icon it states, "You don't have any logs yet."
What am I missing? What step did I miss?
1.) I installed Ubuntu 18.04.4 and the installed OpenVPN Access Server using the scripts.
2.) I opened ports 443 and 1194 on our router and pointed them to the IP address of the OpenVPN Access Sever.
I can successfully log into the Admin UI and the User UI from outside our network using the openvpn admin username and password..
Next, I log into the User UI and click the "OpenVPN Connect Recommended for your device" to download and install the OpenVPN Connect Setup Wizard. So far so good.
When I launch OpenVPN connect, I click on the "OpenVPN Profile" that was created by the installation wizard and enter my username and password. (NOTE: I'm using the openvpn admin username and password since I know that account works.)
After about a minute, it times out with the following error message. "There was an error attempting to connect to the selected server" With the option to, "Cancel" or "Retry"
When I click on the log file icon it states, "You don't have any logs yet."
What am I missing? What step did I miss?