Page 1 of 1

multi-client vlan-pvid setting

Posted: Sat Apr 23, 2011 7:54 am
by mctiew
I am testing the feat_vlan_tagging branch. I am a bit confused over the use of the parameters.

I have set on the multi-client server these :-

--vlan-accept tagged
( I also tested vlan-accept all )

On one of the clients, I set :-
--vlan-pvid 10

presumably this will set this particular client to VLAN ID 10.

However when I sniff the traffic at the server I don't see any VLAN tagging in the traffic. The documentation seems to say that the vlan-pvid is a server setting. But if it is a server setting, how could I make it per client ?

Re: multi-client vlan-pvid setting

Posted: Fri Nov 11, 2011 3:32 pm
by janjust
@Stevey11: your answer has nothing to do with OpenVPN; please ask your questions at a relevant PowerConnect forum.