This is my client conf file:
Code: Select all
client
dev tun
proto udp
remote vlus-it-ovpn-udp.pointtoserver.com 53
persist-key
persist-tun
ca ca.crt
tls-auth Wdc.key 1
cipher AES-256-CBC
comp-lzo
verb 1
mute 20
route-method exe
route-delay 2
route 0.0.0.0 0.0.0.0
auth-user-pass login.cfg
auth-retry interact
ifconfig-nowarn
auth-nocache
Code: Select all
Wed Jan 17 22:05:37 2018 UDPv4 link local (bound): [undef]
Wed Jan 17 22:05:37 2018 UDPv4 link remote: [AF_INET]172.111.145.2:53
Wed Jan 17 22:05:38 2018 TCP/UDP: Incoming packet rejected from [AF_INET]104.250.172.1:53[2], expected peer address: [AF_INET]172.111.145.2:53 (allow this incoming source address/port by removing --remote or adding --float)
Wed Jan 17 22:05:40 2018 [PureVPN] Peer Connection Initiated with [AF_INET]172.111.145.2:53
Wed Jan 17 22:05:42 2018 TUN/TAP device tun0 opened
Wed Jan 17 22:05:42 2018 do_ifconfig, tt->ipv6=0, tt->did_ifconfig_ipv6_setup=0
Wed Jan 17 22:05:42 2018 /sbin/ifconfig tun0 172.111.145.102 netmask 255.255.255.224 mtu 1500 broadcast 172.111.145.127
Wed Jan 17 22:05:44 2018 Initialization Sequence Completed
Wed Jan 17 22:05:48 2018 TCP/UDP: Incoming packet rejected from [AF_INET]104.250.172.1:53[2], expected peer address: [AF_INET]172.111.145.2:53 (allow this incoming source address/port by removing --remote or adding --float)
If I run "ip route list" on my router this is the resulting output:
Code: Select all
0.0.0.0/1 via 104.250.172.97 dev tun0
default via 104.250.172.97 dev tun0
default dev dsl scope link metric 2
104.250.172.1 dev dsl scope link
104.250.172.96/27 dev tun0 scope link src 104.250.172.113
128.0.0.0/1 via 104.250.172.97 dev tun0
151.75.202.50 dev dsl metric 2
169.254.0.0/16 dev lan scope link src 169.254.1.1
192.168.178.0/24 dev lan scope link src 192.168.178.1
192.168.178.201 dev dsl scope link metric 2
192.168.179.0/24 dev guest scope link src 192.168.179.1
192.168.180.1 dev dsl scope link metric 2
192.168.180.2 dev dsl scope link metric 2
193.70.152.15 dev dsl metric 2
212.52.97.15 dev dsl metric 2