Im very much a visual learner and as I go I have been documenting my setup.
See Image.
https://pasteboard.co/GRSMlHG.png
Basically Im after some advice on static routing. As I assume that is what I require.
The PC located on the 192.168.1.0 network cannot access anything on the far 192.168.3.0 network. However All items on the 192.168.3.0 network have reach down into 1.0
I have tried adding the following static route to the PC
route ADD 192.168.3.0 MASK 255.255.255.0 192.168.2.2 -p
(The 192.168.2.2 is what is shown as the p-t-p gateway on the syno NAS for the tunnel)
However that is not working. Any suggestions?
Cheers
Edit
Also see Syno NAS routing table
and PC routing table.
The only one I don't have access to is the shitty ISP Router.....maybe some work needs to be done here?
SYNO NAS
PC
