Good morning !
I have a synology NAS which works as a open vpn server.
The basic functions all works, but I have a little problem.
If I connected with a foreign network, I can connect to my vpn without any Problems.
But I can reached (for example) my Fritzbox via 192.168.178.1 or other devices.
This situation is only a foreign networks. If I am connected via mobile network => no problems.
Here my vpn config - can you tell me, where is my mistake ?
dev tun
tls-client
remote MY_VPN_SERVER_IP MY_PORT
# The "float" tells OpenVPN to accept authenticated packets from any address,
# not only the address which was specified in the --remote option.
# This is useful when you are connecting to a peer which holds a dynamic address
# such as a dial-in user or DHCP client.
# (Please refer to the manual of OpenVPN for more information.)
#float
# If redirect-gateway is enabled, the client will redirect it's
# default network gateway through the VPN.
# It means the VPN connection will firstly connect to the VPN Server
# and then to the internet.
# (Please refer to the manual of OpenVPN for more information.)
#redirect-gateway def1
# dhcp-option DNS: To set primary domain name server address.
# Repeat this option to set secondary DNS server addresses.
#dhcp-option DNS DNS_IP_ADDRESS
pull
# If you want to connect by Server's IPv6 address, you should use
# "proto udp6" in UDP mode or "proto tcp6-client" in TCP mode
proto udp
script-security 2
comp-lzo
reneg-sec 0
cipher AES-256-CBC
auth SHA512
auth-user-pass
<ca>
-----BEGIN CERTIFICATE-----
XXX
-----END CERTIFICATE-----
-----BEGIN CERTIFICATE-----
XXX
-----END CERTIFICATE-----
</ca>
