flow77 Hi there, I hope somebody can help me out of this: I got about 100 Linux Hardware routers that all have the same LAN Network (192.168.99.0/24). The Routers should be connected to an OpenVPN Server and then the Routers and the Devices in the Router LAN should be reachable by Clients who are also connected to the OpenVPN Server. There Client LAN Subnet cannot be changed (already configured live Networks). Router1 VPN-IP: 10.10.0.6 LAN: 192.168.99.0/24 Router2 VPN-IP: 10.10.0.8 LAN: 192.168.99.0/24 (...) Client1 VPN-IP: 10.10.0.10 --- I was trying different settings and I'm currently ended in the following solution: To make the router LAN reachable by the Clients, I'm adding "iroute 192.168.99.0 255.255.255.0" to the router ccd file, adding the route on the server and killing the router connection with the telnet management interface. If there is already a Router configured I need to remove the iroute and routing from the ccd file and also kill the router connection. The problem in this solution is that I can only make one Router LAN reachable at one time. And also I need first kick the VN Connection of the Router. I think the best would be to link the current router connection to a single client, like "ip route add 192.168.99.0/24 dev tun0 src 10.10.0.6 via 10.10.0.8" But I didn't get this working - especially because the "iroute 192.168.99.0" can only be set one time in the ccd. Are there any other ideas out there, maybe some NAT-Hacks or somethign else? Also a solution without the need for the iroute would be great. Thank you in advance for your ideas. Kind regards, Flo
TinCanTech flow77 wrote got about 100 Linux Hardware routers that all have the same LAN Network (192.168.99.0/24) You need qualified support: tincanteksup <at> gmail
