godFuture Hi all, after reading hours of documentation and forum, I end up here. Resigned to go on further without knowing what I do, I would rather enjoy doing it systematically. My issue I do not have connection to my openVPN server during VPN connection and pushed DNS server does not reply to dns requests (checked with wireshark). Also redirecting internet traffic does not work. My setup I use a Ubuntu x64 16.04 computer to host openvpn server. It is connected per cable to router. I have installed dnsmasq for DHCP and DNS services on the same machine openVPN is installed. I would like to access my local network from outside and redirect all traffic (dns + internet) through my vpn connection. Since my setup worked in the past, I am highly motivated to bring it back to life. As I dont want to be without it. Is someone capable to have a closer look at my computer by remote? In the end, it is the fastest way to configure, test and proceed. I could past all the configurations, but I will never be sure to edit configuration right.
Traffic The best place to start is with the Forum Rules (top of this page) Reading the HOWTO is also a good idea .. If you want someone to dial in and do it all for you I can but I will expect payment.
godFuture Traffic wroteThe best place to start is with the Forum Rules (top of this page) Reading the HOWTO is also a good idea .. If you want someone to dial in and do it all for you I can but I will expect payment. What is the cost?
godFuture hi folks, I have found out that linux kernel might be the issue. I have in installed ubuntu 14.04 (kernel 3.13) in a VM and tested openvpn with copied config from my productive server (also added ip forwarding and MASQUERADE). It worked just fine! Then I have switched to the kernel of my prod server, 4.4.2. Since then, also added IP-F and M, it did not work anymore. Does someone redirect all traffic through tun on a kernel bigger than 4.x.x?
