I have got the synology nas which was able to provide open VPN function. It was set automaticly and i was happy until I had to reinstll nas firmware from zero
Now during the connection i get
Fri Feb 13 16:55:47 2015 OpenVPN 2.3.6 x86_64-w64-mingw32 [SSL (OpenSSL)] [LZO] [PKCS11] [IPv6] built on Dec 1 2014
Fri Feb 13 16:55:47 2015 library versions: OpenSSL 1.0.1j 15 Oct 2014, LZO 2.08
Enter Management Password:
Fri Feb 13 16:55:57 2015 WARNING: No server certificate verification method has been enabled. See http://openvpn.net/howto.html#mitm for more info.
Fri Feb 13 16:55:57 2015 UDPv4 link local (bound): [undef]
Fri Feb 13 16:55:57 2015 UDPv4 link remote: [AF_INET]xx.xx.xx.xx:1194
Fri Feb 13 16:55:57 2015 TLS Error: client->client or server->server connection attempted from [AF_INET]89.66.66.151:1194
Fri Feb 13 16:55:59 2015 TLS Error: client->client or server->server connection attempted from [AF_INET]89.66.66.151:1194
Fri Feb 13 16:56:03 2015 TLS Error: client->client or server->server connection attempted from [AF_INET]89.66.66.151:1194
Fri Feb 13 16:56:11 2015 TLS Error: client->client or server->server connection attempted from [AF_INET]89.66.66.151:1194
Fri Feb 13 16:56:15 2015 SIGTERM[hard,] received, process exiting
My config file looks like this
dev tun
tls-client
remote xx.xx.xx.xx 1194
# The "float" tells OpenVPN to accept authenticated packets from any address,
# not only the address which was specified in the --remote option.
# This is useful when you are connecting to a peer which holds a dynamic address
# such as a dial-in user or DHCP client.
# (Please refer to the manual of OpenVPN for more information.)
#float
# If redirect-gateway is enabled, the client will redirect it's
# default network gateway through the VPN.
# It means the VPN connection will firstly connect to the VPN Server
# and then to the internet.
# (Please refer to the manual of OpenVPN for more information.)
#redirect-gateway
# dhcp-option DNS: To set primary domain name server address.
# Repeat this option to set secondary DNS server addresses.
#dhcp-option DNS DNS_IP_ADDRESS
pull
# If you want to connect by Server's IPv6 address, you should use
# "proto udp6" in UDP mode or "proto tcp6-client" in TCP mode
proto udp
script-security 2
ca ca.crt
comp-lzo
reneg-sec 0
auth-user-pass
If you could help it would help me soooooo much. I wasted over a week checking port forwarding and routers but everything is fine.
