Cannot access network resources over VPN

EscapeVelocit3y

Server Config:

local my.server.com 
port 1194
proto udp
dev tun
topology subnet
ca /mnt/Files/openvpn/keys/ca.crt
cert /mnt/Files/openvpn/keys/server.crt
key /mnt/Files/openvpn/keys/server.key
dh /mnt/Files/openvpn/keys/dh1024.pem
server 10.8.0.0 255.255.255.0
ifconfig-pool-persist ipp.txt
push “route 192.168.0.0″ 255.255.255.0″
route 192.168.0.0 255.255.255.0 10.8.0.1
keepalive 10 120
comp-lzo
persist-key
persist-tun
verb 3

Client config:

client
dev tun
proto udp
remote 192.168.0.100 1194
resolv-retry infinite
nobind
persist-key
persist-tun
ca /ca.crt
cert /joe.joe.crt
key /joe.joe.key
ns-cert-type server
comp-lzo

My router IP is 192.168.0.1

My VPN is on 192.168.0.100 and when I VPN into the server my client gets IP 10.8.0.10.

I want to have access to 192.168.0.5 but I cannot from my client system. I think I need to add some routing option to the OpenVPN server running on FreeNAS, but I really don't know how, where and what to do.

Can anyone help?

maikcat

i noticed you use for remote ip the servers lan,
how exactly do you testing your setup?

also route statement usually used for remote lans (lan-to-lan scenario).
do you want lan-to-lan?

Michael.

EscapeVelocit3y

maikcat wrotei noticed you use for remote ip the servers lan,
how exactly do you testing your setup?

also route statement usually used for remote lans (lan-to-lan scenario).
do you want lan-to-lan?

Michael.

I have a Windows 8 laptop which I installed the OpenVPN client on and I use this to connect to my VPN from outside of my network using a different ISP provider.

I'm not a networking expert but the fact the gateway on my OpenVPN client is 10.8.0.0 and my OpenVPN server is 192.168.0.100 I would have to say that I want to do lan-to-lan scenario.

I also am thinking this is simply a routing problem, but I don't know where to specify the routes: in my router (192.168.0.1), the VPN server (192.168.0.100)? Also I don't know how to specify these routes either.

So I would appreciate all the guidance I can get.

maikcat

for clarification lan to lan means that you want pcs from openvpn server side need to access pcs
in your openvpn clients lan.

also remove this from your config

route 192.168.0.0 255.255.255.0 10.8.0.1

if you need lan-to-lan you need to enable & use ccd files...

Michael.