Hello there, is possible to make server configuration, which is forwarding each client to separate tap interface? I made bridge on my openvpn server and added there lan interface, tap0 and tap1. IN configuration file I have [b]dev tap0 tap1[/b]. I thought that it will use separate interface for each client but when I connected two different clients to the server all traffic goes through tap0 interface.

tap interface for each client

romulus

Hello there,

is possible to make server configuration, which is forwarding each client to separate tap interface?

I made bridge on my openvpn server and added there lan interface, tap0 and tap1. IN configuration file I have dev tap0 tap1. I thought that it will use separate interface for each client but when I connected two different clients to the server all traffic goes through tap0 interface.

romulus

I know that this is little bit waste of resources but I would like to do this anyway.
What should I write in server config file to make each interface listening on different port?

romulus

local Public_IP
port 1194
proto udp
dev tap0 tap1

this is how looks part of server.conf file, I cannot find how to bind specific port with tap device.
One advice, which is deleted now, is that i can find it in Manual. But there isn't described this case.

romulus

So I was little looking for solutions and it looks that way for having connected clients through specific tap interface is have config file with specified tap device and port. I do not have many clients so it could be good solution. But here I'm confused with part bridge-server and its ip address. Can i have the same in all config files? I would really appreciate any note with advices. 🙂
Roman