phlkb
Greetings to the forum
I am a week old in this community and need your help.
I have installed the openVPN_as access server successfully and all clients can connect without any issue.
Our network is on the 192.168.1.0/24 subnet and the openvpn server is distributing IP's to the clients on the 172.18.18.0/24 subnet.
We mostly use the vpn to connect our SIP software to our VOIP PBX with our iphones.
The problem is that the PBX (Openscape Siemens) does not allow any connection if the client id not on the same network 192.168.1.0/24 and blocks it.
So I thought to let the openVPN access server distribute IP's on the same network or give IP addresses from our DHCP server.
It seems that this installation does not allow to distribute IPs on the same network, I have tried that from the Admin web interface and the complete server crashed. (Had to re-install)
If I set on the client side static IP's from the 192.168.1.0/24 network, clients do get the IPs but cannot connect to any internal appliance on the network.
The only solution I found was to set the VPN server to be in routing mode and not NAT, but the then the iphone client does not support the TAP.
Any help on the matter will be much appreciated.
Kind Regards
IOANNIS
