Hello,
I am facing some issue while using openvpn tap driver over windows.
I follow the tutorial over following link,
http://backreference.org/2010/03/26/tun ... -tutorial/
Can anyone please share some steps / command line commands for windows which performs following steps:
--- set ip address and subnet mask (currently I am doing this through property window)
--- Enable(UP) the tap interface
--- Enable IP forwarding
--- set nat iptable rule to rewrite the IP address in the frame leaving the physical interface
I can do above things in linux, but I am not aware on How to do the same on windows.
Following are the issues:
1) I am not able to ping the IP address set for the tap interface though it's enabled, where as in linux it can be done.
like suppose I have use 10.0.0.1/24 for tap interface, and trying "ping 10.0.0.1" results in time out on windows.
2) When I run the application, I receives unwanted frames over tap, like some ARP packets asking who has X.X.X.X ? tell 0.0.0.0
As well as some other IPv6 and DHCP protocol frames.
My final goal is to access the internet using TAP interface. Route the frames from tap to physical interface(eth0).
Kindly share any tutorial/link for windows command line setup for tap interface.
Also how can we use NAT table rules over windows.
How can I rewrite the IP address leaving the eth0 interface. ( as like in linux it can be done using ip tables NAT Masquerade rule)
