Hey guys, I need some help setting up multiple IP's on my openvpn server hosted at RamNode.
I used this tutorial (
http://yaui.me/how-to-set-up-openvpn-in-30-seconds-or-less/) to set up a Debian 32-bit openvpn server and I can log-in and use my vpn freely, this was suprisingly simple.
I need some help however using multiple IP's. I'm planning on reselling my VPN service and using the extra-ip I ordered. I am able to connect to my main IP (x.x.x.35) and my additional one (x.x.x.36) just fine (both have DNS records setup), however when I connect to my additional IP (x.x.x.36) my external IP remains the main one (x.x.x.35). I would like to have my setup as such to route incoming connections from one IP through the same IP out, preferably without running multiple openvpn instances (but if this isn't possible, you might aswell. I also have no clue how to do this. 😛).
I am a newcomer when it comes to linux, so any support is appreciated provided you explain clearly. I'm only trying to get better. 😛
Information:
My VPS package comes with 16 IPv6 addresses, and 1 (+ 1 extra) IPv4 address.
Internet interfaces:
venet0: x.x.x.35
venet0:0: x.x.x.35
venet0:17: x.x.x.36
VPN Mode:
Layer 3 (routing/NAT)
PPP and TUN/TAP are enabled (no clue what they mean, but they're important apparently 🙂)
Thanks in advance.
- Darth
