scoutjv Hi Folks, it's my first time using OpenVPN and almost all works perfect from scratch. I only have one issue. I running an OpenVPN client on a Windows 2008 R2 terminalserver. As soon as I connect with the OpenVPN client, no other PC inside the network can access the terminalserver. I also can't ping the terminalsever. I connect from other clients without any problems. Does anyone experienced such a behavior? I appreciate any help. With regards scoutjv
scoutjv Hello maikcat, thanks for your reply. Here is the client config file. client dev tun proto udp remote server.stratoserver.net 1194 resolv-retry infinite nobind persist-key persist-tun ca ca.crt cert client.crt key client.key ns-cert-type server comp-lzo verb 3
scoutjv I'm sorry for the delay response. I was out of the office for some time. Here is the server config file. ################# port 1194 proto udp dev tun ca ca.crt cert server.crt key server.key dh C:\\Progra~2\\OpenVPN\\config\\dh1024.pem server 10.8.0.0 255.255.255.0 ifconfig-pool-persist ipp.txt keepalive 10 120 comp-lzo persist-key persist-tun status openvpn-status.log log openvpn.log verb 6 management localhost 7505 ##########################
scoutjv Hi Michael, I can ping the server on the other side and also my Standardgateway. But each Terminalserversession will be disconnected as soon as I connect to the VPN and then you neither can connect to the Terminalserver via rdp protocol nor can I ping the Terminalserver until I disconnect the VPN session. It's a very strange behavior. With regards Jürgen
scoutjv Hi, the physical IP Address of the server is 192.168.77.10. The VPN connection gets the IP Address 10.8.0.11. With regards Jürgen
maikcat The VPN connection gets the IP Address 10.8.0.11 if you are not using topology subnet then the vpn ip should be .10 or .9 something is wrong here.... :roll: Michael.
