helloworld Hi I am new to openvpn. I was wondering am I able to setup openvpn server and client on windows 7 32bit. Note: Both the server and client are on the same domain network. (eg.xxxx.org) If so, should i use routing or bridging for my case. In mytesting, i am able to assign my server with ip address 10.8.0.1 using routing. However, i am not able to sucessfully establish a connection for my client side. Please any advice are welcome.
george Note: Both the server and client are on the same domain network. (eg.xxxx.org) Are they on the same subnet? Please post server and client configs.
helloworld Thank you for the reply. Yes they are from the same subnet. The server and client config are as followed: Server: port 1194 proto udp dev tun ca ca.crt cert server.crt key server.key dh dh1024.pem server 10.8.0.0 255.255.255.0 keepalive 10 120 comp-lzo persist-key persist-tun verb 3 client: client dev tun proto udp remote 10.8.0.1 1194 resolv-retry infinite nobind persist-key persist-tun ca ca.crt cert client.crt key client.key ns-cert-type server comp-lzo verb 3 ping 10 ping-restart 60
maikcat hi there, 10.8.0.1 is the openvpn virtual interface address.. you must use the lan ip of your server to connect. what lan ips your pcs have? Michael.
helloworld Hi Thank you for the reply. I have the solve the issue by changing the ip address to the lan of my computer. Thank you once again.
